I’ve said it before, but I do have a thing for LMS Vans. The high sides and shallow roof profile make for a distinctive looking van. These two are both kits from Cambrian Models.
Both of these van’s represent slightly older variants of rolling stock, than the more common ratio van diagram.
First up is a D1676. These vans were built from 1924-1928, with 2956 examples being built. The vans were built as fitted and unfitted, but after finding a nice early 50’s photo in Geoff Kent’s 4mm Wagon Book 2, I went with unfitted. As I mentioned at the beginning, this is a good example of an older van, but it’s heritage is undeniable.
The second van is a D1832A which are from a slightly later period than the previous van, batches being being built in 1929-1930 and 1930-1931. The actual sides (other than the corrugation) are pretty similar to D1676 and the same as unventilated D1663, which makes commercial sense as production models (I’ve a D1676 to also finish, but in bauxite).
Both caused a little bit of a headache after building, with both developing a wobble. Thankfully I found out it wasn’t something I had done, but down to a case of a poor batch of markits wheels. The vans suffered from roofs too short for the model (they only just reached the ends) so I added microstrip to give the vans their overhang.
Regarding painting, I took a different route after talking to Geoff Kent at Scale Four North. A number of Geoff’s unfitted wagons are painted a lighter shade of grey which I found to be Railmatch’s ‘late grey’. I did discover however that the grey came off with white spirits very easily, even with a coat of Klear on top and after 3 weeks drying time, therefore both vans had two spray coats of Gameworkshop ‘purity seal’ once the transfers were in place.
Prior to weathering I painted over a couple of planks with the same grey, but it has given a nice change of tone on several of the planks. Weathering was done in my usual way, several washes over the body, building up and taking away in places. The chassis is a mix of Matt Black and Revell 84 which was finished off with a touch of powder work. Roofs were painted a mix of Matt Black, Metalcote Gunmetal and a touch of Revell 76 Grey. They were finished with powders to give a good textural finish.
My attention now turns to a couple of Parkside exLNER vans to finish, which with the two LMS vans will form part of my demonstration at Thirsk Model Railway Exhibition at Thirsk Town Hall, 31st July.